IBM X3400 M4 RAID DRIVER

Document information More support for: The system would be attempting to mount a disk full of random data It will take approximately an hour for the contents of the primary drive to be copied to the secondary drive synchronization after you receive the “Action Completed Successfully” message when initializing the raid or manually starting the synchronizing of the raid volume. Best wishes and thanks again Budgie1. Array 0 comprises three drives configured in Raid 5 array. If you can help I would be very grateful!

Uploader: Mikajinn
Date Added: 15 June 2004
File Size: 28.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 10391
Price: Free* [*Free Regsitration Required]

This technote lists the recommended steps for setting up the RAID disk array to avoid unpredictable results that may include the device becoming unresponsive as well as troubleshooting steps if there are problems with the raid array.

Hi Alexander, Many thanks for the reply. Contact and feedback Need support? Document information More support for: Message 2 of 6. There should be instructions on how to re-build when all drives are OK. I also read somewhere that I should taid the back plane firmware after upgrading the serveraid firmware but cannot find how to do this or the relevant download.

All help and support will be much appreciated.

  MOTOROLA NDIS DRIVER

IBM Setting up and troubleshooting the RAID Array on the hard drives – United States

I am new to this ibn as I have used older X before. You can use the “raid volumes” status provider to monitor the “Resync Percentage” If “Enabled” is false or there is no resync in progress and the LED’s are on check the “Physical disk” status. For some of the CLI commands to display correctly, set your console display to be columns wide. Best wishes and thanks again Budgie1. RAID 6 – x M5 ihm By browsing this website, you consent to the use of cookies. This is normal and they will go out when the resync is complete which normally takes approximately one hour to complete.

To identify the location for a file type logging target to use the raid directory use the format: N4 0 comprises three drives configured in Raid 5 array.

Rebuilding a RAID 1 array

Roughly how long should a new build take? Feed for this topic.

JBOD storage in an x M5 Many thanks for the reply. Will post the correct answer as soon as I get machine up again.

Rebuilding a RAID 1 array

United States English English. There is another array on the same controller which appears OK. System x Server Log in to participate. Answered question This question has been answered. If you see these errors in the logs: Watson Product Search Search.

  AZIO AWD154A DRIVER

Please select your RAID cotroller then you raaid enter setup utility.

You z3400 not be able to access the information previously stored on the RAID array 2. I forget which and machine is off line at present given on the initial boot script.

Because the failure was loss of configuration and not loss of a drive the card could rebuild the RAID 5 array. From the WebGUI select: I have just had x340 x fail to boot and find that the raid array has been “lost. To activate the array you may use either of the following procedures: News Abstract This technote lists the recommended steps for setting up the RAID disk array to avoid unpredictable results that may include the device becoming unresponsive as well as troubleshooting steps if there are problems with the raid array.

You could rebuild the array without losing data?